« previous next »
Pages: [1]

Author Topic: Where to draw 5v on the Turbografx 16  (Read 223 times)

Shear_xear

  • Newbie
  • *
  • Posts: 19
Where to draw 5v on the Turbografx 16
« on: February 10, 2016, 01:59:01 PM »
Hi everyone.  I have installed my Obey chip, and need to draw an additional 5v for my component chip.  I used the Hu Card pin for the Obey chip... Where else are good points to get 5v from the Turbografx?  Thanks a lot!  Mike Shear
Logged

mickcris

  • Hero Member
  • *****
  • Posts: 754
Re: Where to draw 5v on the Turbografx 16
« Reply #1 on: February 10, 2016, 02:02:49 PM »
you can get it right from the 7805 output pin.
Logged

Shear_xear

  • Newbie
  • *
  • Posts: 19
Re: Where to draw 5v on the Turbografx 16
« Reply #2 on: February 10, 2016, 02:27:46 PM »
Okay, that is easy enough.  Thanks!
Logged

wilykat

  • Hero Member
  • *****
  • Posts: 908
Re: Where to draw 5v on the Turbografx 16
« Reply #3 on: February 12, 2016, 03:37:17 AM »
Make sure you get the right side.  When facing the 7805 with the visible number and the pins pointing down, the left pin is unregulated input and will likely fry your chip. Middle pin is ground and your chip will just not work at all. Right pin is regulated 5v and it is the one you want.

https://www.sparkfun.com/datasheets/Components/LM7805.pdf the first page has picture with pinout if you need to print it and have it by your system and soldering iron.
Logged
Pages: [1]
« previous next »