« previous next »
Pages: [1]

Author Topic: Best way to separate the 2 plastic halves of a TurboPad connector?  (Read 345 times)

NinSEGA

  • Newbie
  • *
  • Posts: 22
Best way to separate the 2 plastic halves of a TurboPad connector?
« on: February 01, 2021, 04:04:34 PM »
I need to repair an 8-DIN connector to a TurboPad that is missing its pins and the shielding on the end-




I already have an 8-DIN pin connector that I can source the parts from.
Logged

majors

  • Hero Member
  • *****
  • Posts: 1332
  • Have cabs, will travel
Re: Best way to separate the 2 plastic halves of a TurboPad connector?
« Reply #1 on: February 02, 2021, 12:53:11 PM »
I'd just replace the whole cable...seems easier than splicing a cord with a replacement DIN. I find it a pain to solder those DIN connections on the inside.
Logged
PCE Daisakusen RIP - "Booze should be a choice, not a privilege" -KCDC (The FP)
"The dumb are mostly intrigued by the drum"

Keith Courage

  • Hero Member
  • *****
  • Posts: 2690
Re: Best way to separate the 2 plastic halves of a TurboPad connector?
« Reply #2 on: February 02, 2021, 09:31:34 PM »
Unless you have the metal part that came out then replacing the cable itself is the best option. https://console5.com/store/turbografx-turbopad-repair-cable-tg16-turbo-grafx-controller-pad.html

If you still have the metal part and all the pins on it are still good, then you can glue them back in. I've done this many times with good results.

« Last Edit: February 02, 2021, 09:33:44 PM by Keith Courage »
Logged
Pages: [1]
« previous next »