Author Topic: How to properly connect a Supergrafx to a Super CDrom2?  (Read 323 times)

Supercom

  • Newbie
  • *
  • Posts: 25
How to properly connect a Supergrafx to a Super CDrom2?
« on: May 29, 2016, 07:39:44 AM »
Hello, quick question. According to the manuals what is the proper way to connect power to a Supergrafx system and a Super CD-rom 2 combo?
 Do each need their separate Ac adapters?



Thanks for any replies.

Black Tiger

  • Hero Member
  • *****
  • Posts: 11242
Re: How to properly connect a Supergrafx to a Super CDrom2?
« Reply #1 on: May 29, 2016, 08:02:51 AM »
Separate ACs unless you get the custom power cable.
http://www.superpcenginegrafx.net/forum

Active and drama free PC Engine forum

Supercom

  • Newbie
  • *
  • Posts: 25
Re: How to properly connect a Supergrafx to a Super CDrom2?
« Reply #2 on: May 29, 2016, 08:10:58 AM »
Separate ACs unless you get the custom power cable.

Thanks for your reply. I know there are made up custom non-official patch cables but, was there an official NEC release of this cable?

SignOfZeta

  • Hero Member
  • *****
  • Posts: 8497
Re: How to properly connect a Supergrafx to a Super CDrom2?
« Reply #3 on: May 29, 2016, 10:23:00 AM »
It came with the SuperCDROM2, didn't it?

Bonknuts

  • Hero Member
  • *****
  • Posts: 3292
Re: How to properly connect a Supergrafx to a Super CDrom2?
« Reply #4 on: May 29, 2016, 10:26:21 AM »
I run a single AC adapter, but I run one with more amp output than the stock ones. I figured if both parts of the system was drawing from it, it might as well be beefier. Yeah, and custom cable needs to be made for the pass through.

dj898

  • Full Member
  • ***
  • Posts: 215
Re: How to properly connect a Supergrafx to a Super CDrom2?
« Reply #5 on: June 18, 2016, 10:22:41 PM »
Super CD-ROM2 came with two patch cables - one for PCEngine and the other for SuperGrafx