Hey gusy - looking for some advice on the TG16 cap kit from Console5.com.
So, I purchased a cap kit for the Turbografx 16 a few months back and finally had some time to sit down with them since i was doing a region mod on my system and had it open last night.
When looking through the parts, i noticed that the caps don't match the schematics shown here:
https://console5.com/wiki/TurboGrafx_16Specifically, the Voltage values don't match up as shown.
Is it OK to use different voltage caps?
Should i even replace them if the system works fine? Or should I just set them aside and wait til something goes?
Thanks!